Fluke 5440a manual

By checking this box, I agree to receive marketing communications and product offers by email from Fluke Electronics Corporation, transacting under Fluke . In this manual, a Warning identifies conditions and actions that pose hazard(s) to the user, a Caution identifies conditions and actions that may damage the ProcessMeter Fluke A Low Thermal Test Leads Calibration Module w/Battery Eliminator W No Substitute. A generic battery eliminator might pose a safety hazard. Includes Cal. A Low Thermal Test Leads. Highlights. Highlights. These low thermal test leads have lower thermal emf than standard test leads, minimizing the emf caused by temperature difference between the ends of the leads. Length: 24 in ± 1 in. Connector size: 4 mm diameter.

The Fluke Model A is a highly stable, rugged, and transportable, solid state, dc voltage reference standard. The A has 10V, V and IV outputs. These outputs are available on front panel binding posts. The calibration adjustments for the IOV, V and IV outputs are accessible through the front panel. manual The following tables provide the in-tolerance and out-of-toler-ance limits for each calibration point, calculated as described above. The Fluke A can address all points directly ex-cept for ± µA dc, ±10 mA, and ± mA dc. For those points, use a 10 kΩ resistor like the Fluke Ak to charac-terize the ± µA dc point. In. Search results. application/pdf attached to: Model A Low Thermal Test Lead Set Specification Sheet. High accuracy working standards for on-site resistance calibration Small and rugged resistance calibrators No oil or air baths required 18° to 28° C operating range Six-month stability to ppm.

Product Manuals. , , Users Guide Manual». A, Statement of Memory Volitilty». A/ Thermometer Readouts Users Guides». Statement of Memory Volatility». / Handheld Thermometer Readout User Manuals». , Technical Guide». , Users Guide». Re: Fluke A repair. Check for life on main processorboard, check reset lines, check XO outputs, check if firmware chips on all digitaly boards is good or not. 1. The files that I posted are read from the current boards. Unfortunately, I cannot find out how much the correct firmware is in them. Re: Fluke A repair. «Reply #41 on: Septem, pm». The jumpy reference voltage could be from a cold soder joint, failing bond wire or maybe a bad relay contact. For the heater part the transistor to control the heater is itself a powerful heater.